Hi.
I have tuned my steppers in mach3 and they run smooth at 1000mm/min with acc. set to 200.
Now the speed is to high when cutting in wood, so in my gcode the plunge rate and feedrate are set to 400. But when i do this the steppers doesn't sound right and they loose steps.
I also tried to tune the steppers at 500mm/min, this also causes them to loose steps.
I only thought that i would loose steps when going faster??
But as it is now i can't run my mill slow, so i can't cut in the materials i wan't.
I just can't figure this out, so if you got a clue please feel free to post suggestions! :-)
regards Nic