Hello Guest it is June 04, 2023, 03:24:25 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Mastercam X post for mach2  (Read 4667 times)

0 Members and 1 Guest are viewing this topic.

Offline EPMAltizer

*
  • 2 2
    • View Profile
Mastercam X post for mach2
« on: January 24, 2006, 10:12:17 AM »
Alright ive been looking for a while now, and i cant seem to find a mastercamx post for mach2. if any of you fellow machinists have one or know where i can get one. it would be a great help
thanks
Nick

feel free to email me at DirBiKidnma@hotmail.com
Logged

Offline mhdale

*
  • 130 130
  • Knowledge is the Treasure.
    • View Profile
    • Black Dragon Technologies
Re: Mastercam X post for mach2
« Reply #1 on: January 24, 2006, 12:54:39 PM »
I Have been using my old AH-HA Post for MasterCam, I have yet to finish all the testing to ensure that all is actually working well, if you still need one by then I would be happy to email it to you.

Mike
Logged

Offline EPMAltizer

*
  • 2 2
    • View Profile
Re: Mastercam X post for mach2
« Reply #2 on: January 24, 2006, 08:07:12 PM »
hey thanks mike, but Im not familiar with this "AH-HA" post. if you could inform me, ive checked my mc9/mill/post folder and i dont have one.
thanks
Logged

Offline Brian Barker

*
  • *
  • 3,856 3,856
    • View Profile
Re: Mastercam X post for mach2
« Reply #3 on: January 24, 2006, 08:14:40 PM »
AH-HA should be VERY close to Mach3... I ran an AHHA machine for 5years :) But not now I think Art would be upset if I started to run DOS  ::)
The AH-HA was built to run code like a Fanuc 6M... 
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

ynneb

*
Re: Mastercam X post for mach2
« Reply #4 on: January 25, 2006, 01:13:17 AM »
Is there a difference between MC9 and MCX ?
If not, then you may find what you need near the end of this page
http://users.adelphia.net/%7Ekchris/mach_files.htm
Logged

Offline Mike Francies

*
  • 3 3
    • View Profile
Re: Mastercam X post for mach2
« Reply #5 on: January 25, 2006, 08:48:04 AM »
Have you tried http://users.adelphia.net/%7Ekchris/mach_files.htm ? It's on the Mach Support site. I have just downloaded the MC9 post processor.

Mike
Logged

Offline Mike Francies

*
  • 3 3
    • View Profile
Re: Mastercam X post for mach2
« Reply #6 on: January 25, 2006, 11:38:27 AM »
Ooooops, just realised the link I have given you is the same one as Benny.

Mike
Logged
Pages: 1   Go Up
« previous next »