Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: EPMAltizer on January 24, 2006, 10:12:17 AM
-
Alright ive been looking for a while now, and i cant seem to find a mastercamx post for mach2. if any of you fellow machinists have one or know where i can get one. it would be a great help
thanks
Nick
feel free to email me at DirBiKidnma@hotmail.com
-
I Have been using my old AH-HA Post for MasterCam, I have yet to finish all the testing to ensure that all is actually working well, if you still need one by then I would be happy to email it to you.
Mike
-
hey thanks mike, but Im not familiar with this "AH-HA" post. if you could inform me, ive checked my mc9/mill/post folder and i dont have one.
thanks
-
AH-HA should be VERY close to Mach3... I ran an AHHA machine for 5years :) But not now I think Art would be upset if I started to run DOS ::)
The AH-HA was built to run code like a Fanuc 6M...
-
Is there a difference between MC9 and MCX ?
If not, then you may find what you need near the end of this page
http://users.adelphia.net/%7Ekchris/mach_files.htm
-
Have you tried http://users.adelphia.net/%7Ekchris/mach_files.htm ? It's on the Mach Support site. I have just downloaded the MC9 post processor.
Mike
-
Ooooops, just realised the link I have given you is the same one as Benny.
Mike