Soon I will home my new machine to see how it works. For now all axes working fine except I noticed the Y axis once went askew but then some how it fixed itself – probably the Y axis motor is missing steps? If that is the case should I change the Step / Dir Pulse in the Motor Tuning Table? now both values are set at 5.
On the screen picture attached why the X / Y little arrows at the bottom left corner of the screen are not set at the bottom left corner of my table? I’m I doing something wrong.
I have also attached a picture of my Home / Softlimits Table to find out if I have done anything wrong. All axes on this table are 1 sorter to avoid any crashes just in case I made a mistake.
So when I’m ready which button home the machine? the REF ALL HOME ? Does this change only the DRO’s or it also homes the machine?
Thank you