Hello Guest it is March 29, 2024, 05:46:11 AM

Author Topic: Denford Triac ATC - guidance on updating to Mach3(?)  (Read 20701 times)

0 Members and 1 Guest are viewing this topic.

Offline Sweep

*
  •  150 150
    • View Profile
    • pollz.co.uk
Re: Denford Triac ATC - guidance on updating to Mach3(?)
« Reply #20 on: November 28, 2006, 04:41:08 AM »
Collected the machine yesterday. Got it home and it wouldn't fit through the door  :-[
Not much chance for sub-micron work when I couldn't measure to the nearest inch!
Had to strip off the two rear control panels and even then it was a tight squeeze.
I will have to put it to one side for a few weeks until I finish re-assembling my Smart & Brown lathe, as I don't want too many things in bits at one time, but after that I am sure there will be plenty more challenging questions for all you experts out there in Mach-land.

Thanks ...Richard

p.s. anyone got any spare BT35 toolholders?
Re: Denford Triac ATC - guidance on updating to Mach3(?)
« Reply #21 on: November 28, 2006, 08:17:30 AM »
BT35, I have a friend that has a few of the holders, but they are for his mill :(

Best of luck and good to hear you got it in the door !
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com