Hi,

Can anyone explain why the pullback setting for G73, found under 'Config' / 'Ports and Pins' / 'Mill Options', is not persistent? I want to change this from 0.1mm to 0.25mm and this works while Mach is running but when it is closed down and re-opened, it reverts to 0.1mm. I even tried using the 'Save Settings' on the 'Config' menu but this did not work either.

Is there a good reason why it cannot be persistent?

I searched the forum for an answer and although a few others have noticed the same thing, none has received an answer.

Cheers,

Mike

The reason is, wait for it..............  its broken 

It will get fixed but who knows when 

Graham

Thanks Graham, that just about sums it up I find it strange that it is not a parameter within the G73 code and has to be set elsewhere.

Mike

Believe me its been mentioned too many time to remember just how many, all I can say is the next major version (V4) is supposed to have all these niggles sorted out.

I can't wait to find out if they are, how about you Hood 

Graham