Could someone tell me what are the OEM 91 and 93 DRO?
 How do they work?
 OEM 91 is the pullback DRO?

thanks

Nemo

OEM 91 is G73 Pull-off value DRO and I would imagine that would be the value that the retract would be in the G73 cycle

OEM 93 is Tangential lift Z level DRO which I would image would be the value the Z is lifted before a rotation of the tangential knife.

Hood

Thanks Hood!

 I'll put one OEM91 DRO on the screen , and I'll do a test with G73.
Must be more fast and better than the G83 with a Center Drill . Or not??

Nemo

Look forward to the results, not sure if I have ever used it but I seem to remember that DRO being on a screen before but cant find it now.
Hood

It is in config, ports/pins, mill setup

It is in config, ports/pins, mill setup

Knew I had seen it somewhere, thanks

Hood

 I did a test and I am satisfied with the results.

Hood & BR549...Thank  you all.

Nemo

Good to hear.

Hood