Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: nemoc on January 16, 2011, 01:53:40 PM
-
Could someone tell me what are the OEM 91 and 93 DRO?
How do they work?
OEM 91 is the pullback DRO?
thanks
Nemo
-
OEM 91 is G73 Pull-off value DRO and I would imagine that would be the value that the retract would be in the G73 cycle
OEM 93 is Tangential lift Z level DRO which I would image would be the value the Z is lifted before a rotation of the tangential knife.
Hood
-
Thanks Hood!
I'll put one OEM91 DRO on the screen , and I'll do a test with G73.
Must be more fast and better than the G83 with a Center Drill . Or not??
Nemo
-
Look forward to the results, not sure if I have ever used it but I seem to remember that DRO being on a screen before but cant find it now.
Hood
-
It is in config, ports/pins, mill setup
-
It is in config, ports/pins, mill setup
Knew I had seen it somewhere, thanks
Hood
-
I did a test and I am satisfied with the results.
Hood & BR549...Thank you all.
Nemo
-
Good to hear.
Hood