Hello Guest it is September 15, 2019, 07:02:16 PM

Author Topic: Mach3 stops and looses control  (Read 6969 times)

0 Members and 1 Guest are viewing this topic.

Re: Mach3 stops and looses control
« Reply #20 on: January 17, 2011, 05:03:30 PM »
Hi,

I am having the same issue, I am able to repeatably have 3 different programs stop on lines 495-497, I can take the programs and remove some lines and start them again and they will run through that line until they again hit lines 495-497. Any ideas?

Offline Hood

*
  •  25,849 25,849
  • Carnoustie, Scotland
    • View Profile
Re: Mach3 stops and looses control
« Reply #21 on: January 17, 2011, 05:04:57 PM »
You are using the demo version, it is limited to 500 lines.
If you have a licence then it is either in the wrong location or it is corupt.
Hood