Hello Guest it is July 18, 2025, 04:44:43 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Using Mach3 and Camworks  (Read 12560 times)

0 Members and 1 Guest are viewing this topic.

debutpic

*
Using Mach3 and Camworks
« on: November 11, 2006, 10:49:33 AM »
Hello all
I use since several years the CAD/CAM package Solidworks/Camworks
but do you know if a postprocessor exist for Mach3 ?

thank's
Logged

Offline Graham Waterworth

*
  • *
  • 2,783 2,783
  • Yorkshire Dales, England
Re: Using Mach3 and Camworks
« Reply #1 on: November 11, 2006, 01:55:30 PM »
A Fanuc 6m or 15m post should be very close.

Graham.
Logged
Without engineers the world stops

debutpic

*
Re: Using Mach3 and Camworks
« Reply #2 on: November 12, 2006, 04:06:49 AM »
Thank's Graham,I will try with this post.
Do you work with Camworks and Mach 3 because
I did not see of Topic which uses this two software?
« Last Edit: November 12, 2006, 04:16:15 AM by debutpic »
Logged

Offline Graham Waterworth

*
  • *
  • 2,783 2,783
  • Yorkshire Dales, England
Re: Using Mach3 and Camworks
« Reply #3 on: November 12, 2006, 04:08:25 AM »
No.

Graham.
Logged
Without engineers the world stops

debutpic

*
Re: Using Mach3 and Camworks
« Reply #4 on: November 12, 2006, 04:24:04 AM »
 Do you know or I can find a good support for Camworks and Mach3 ?
Logged

Offline Graham Waterworth

*
  • *
  • 2,783 2,783
  • Yorkshire Dales, England
Re: Using Mach3 and Camworks
« Reply #5 on: November 12, 2006, 04:27:33 AM »
This is the best place for Mach3, Camworks, don't know.

Mach3 has Lazycam built in and will do alot of what you want, you may not need Camworks.

Graham.
Logged
Without engineers the world stops
Pages: 1   Go Up
« previous next »