Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: debutpic on November 11, 2006, 10:49:33 AM
-
Hello all
I use since several years the CAD/CAM package Solidworks/Camworks
but do you know if a postprocessor exist for Mach3 ?
thank's
-
A Fanuc 6m or 15m post should be very close.
Graham.
-
Thank's Graham,I will try with this post.
Do you work with Camworks and Mach 3 because
I did not see of Topic which uses this two software?
-
No.
Graham.
-
Do you know or I can find a good support for Camworks and Mach3 ?
-
This is the best place for Mach3, Camworks, don't know.
Mach3 has Lazycam built in and will do alot of what you want, you may not need Camworks.
Graham.