I', looking for the post to run my Master Cam MR2 (10.2.2.31) also says Ver. 0.17.1.167. I would like to do my drawning in my autocad and run through my Master Cam which I use in my shop. Any help would be good.

May I express my master no information offline.

Don't understand the reply....sort of like a cypher.
RICH

What version of Mastercam? X - X5, lathe or mill post? MR2 doesn't tell me much. Thats just the maintenance release.  I have been working on a lathe post for X5

i used mastercam 14 and i need to know what post to use because tha mpfan make tha machine loca loca

because tha mpfan

Don't understand..

RICH

Mpfan is a generic post for Mastercam.  If you purchased Mastercam you should have no problem getting a post from your dealer.

ok but my Q WAS which post I need to ask for

Well just guessing here BUT if you are using MACH3 I would ASK for a post for MACH3.

Just a thought, (;-) TP

I think a regular FANUC post would work.(already in mastercam)

Will probably have to make some changes in the header file but the code will work.


Jeff