I have noticed an intermittent problem. Sometimes movements in the Y direction just stop being executed. The other 1425 I helped set up might be having the same problem, but its not near by to test with.
Example: I can hold down the arrow key, and it will just stop jogging. If I let go and press it again it will start jogging again.
I swapped the X and Y output and encoder inputs on my Break out box, and the problem switched to the other Axis. This tells me its a problem in my motion controller or computer.
I swapped to another Galil 1425, and it also had the problem
I made a new profile in Mach3, it still did it. I checked out galildebug.txt and it showed the proper commands.
I tried the stable and the experimental version of Mach 3, both had the problem. Then I tried V4.3, V4.4, and the special version of V4.4 of galil.dll that was posted above. All did the same thing.
Then I tried changing the Axis Mapping in the Galil Plugin. This is where things get interesting.
When X is mapped to X, and Y to Y, I have intermittent problems with Y's motion stopping.
When X is mapped to Y, and Y to X, when I jog X on the computer, it will move Y on the machine, but only in one direction. In the other direction it goes about .0002 and stops.
I'm slowly getting this tracked down, but if anyone has any ideas im open to ideas.