hello out there.

Im getting ready to start building my cnc mill and i have a rough idea about what im doing. but Im not one for trial and error. so i was wondering if anyone could point me to a fairly user friendly set of diagrams or something that might help me to put the electronics in order in my head before i start.I will be using Mach software of course. I have a power supply already ready to go. am using a servo setup with encoders and I have bought a breakout board from mister campbell. I will be using Gecko drivers with a fourth axis. the fourth axis will be a stepper motor without an encoder. thats all the information i can think of but if anyone can point me toward a idiots guide type of thing that'd be great. Not that Im an idiot mind you. just cautiouse.

Hello Bathgate,
     I should have a good wiring diag. of my control cabinet next week. I have all of the stuff packed in a small box, lying on the table beside the box, you know, lets hook it up and see this puppy run kinda mess. As crazy as it sounds, I have not had any noise problems. I'm building my new cabinet end of this week, first of next. I'm only running steppers, no encoders. I'll give you what I have.

Check out my web site. I have some schematics there that my help you
Look on the download page you will find two files one is Electrical Control Box.dwf 117KB the other is Pin outs & MPG.pdf 49KB.
The Electrical Control Box.dwf You will need Autodesk Express Viewer to view the file.

Duke..
I tried your web site but Earthlink tells me you don't exist...
  Is there something I'm not doing right?   ...Or is there a problem with your web site?

Thanks,  John (Bloy)

Sorry about that forgot that I changed providers

http://users.wildblue.net/GMDUKE/