Hello Guest it is April 20, 2024, 12:39:07 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: ALL AXIS MOVE WHEN POWER IS APPLIED  (Read 3457 times)

0 Members and 1 Guest are viewing this topic.

Offline inivator

*
  • 102 102
    • View Profile
ALL AXIS MOVE WHEN POWER IS APPLIED
« on: September 07, 2010, 07:27:54 PM »
THE MACHINE WAS WORKING, BUT NOW WHEN I APPLY POWER TO THE DRIVES THEY ALL STARTMOVING.  I CAN CHANGE DIRECTION OF MOVEMENT WITH THE JOG BUTTONS, BUT CAN'T STOP MOVEMENT......USING A 3 AXIS PROBIIX........
« Last Edit: September 07, 2010, 07:37:32 PM by inivator »
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: ALL AXIS MOVE WHEN POWER IS APPLIED
« Reply #1 on: September 08, 2010, 02:20:29 AM »
Do the DROs in Mach show movement?
Hood
Logged

Offline inivator

*
  • 102 102
    • View Profile
Re: ALL AXIS MOVE WHEN POWER IS APPLIED
« Reply #2 on: September 08, 2010, 09:19:30 AM »
NO...USING STEPPERS, AND WHERE WOULD THE DRO BE SHOWING..
Logged

Offline manmeran

*
  • 241 241
    • View Profile
Re: ALL AXIS MOVE WHEN POWER IS APPLIED
« Reply #3 on: September 08, 2010, 10:13:44 AM »
maybe "GROUND"
check your ground between PC and driver.

Amir
Logged
**Even a clock that does not work is right twice a day**

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: ALL AXIS MOVE WHEN POWER IS APPLIED
« Reply #4 on: September 08, 2010, 10:28:25 AM »
The readouts in Mach for each axis. Do they show the axis is moving when your motors move and are not meant to be?
Hood
Logged
Pages: 1   Go Up
« previous next »