Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: inivator on September 07, 2010, 07:27:54 PM
-
THE MACHINE WAS WORKING, BUT NOW WHEN I APPLY POWER TO THE DRIVES THEY ALL STARTMOVING. I CAN CHANGE DIRECTION OF MOVEMENT WITH THE JOG BUTTONS, BUT CAN'T STOP MOVEMENT......USING A 3 AXIS PROBIIX........
-
Do the DROs in Mach show movement?
Hood
-
NO...USING STEPPERS, AND WHERE WOULD THE DRO BE SHOWING..
-
maybe "GROUND"
check your ground between PC and driver.
Amir
-
The readouts in Mach for each axis. Do they show the axis is moving when your motors move and are not meant to be?
Hood