Hello Guest it is March 02, 2024, 11:52:11 AM

Author Topic: Emco VMC100  (Read 3709 times)

0 Members and 1 Guest are viewing this topic.

Emco VMC100
« on: September 05, 2010, 05:44:32 AM »
I am about to embark on a new project to replace the cnc controller on my machine with a pc based Mach3 system . I have not yet decided how to move forward as i will not get the machine until next weekend . Has anyone tried and succeeded in getting one of these little lovelys up and running with Mach3 . If so can you advise on what was used and what problems I may encounter . Thanks for looking .
Re: Emco VMC100
« Reply #1 on: August 25, 2012, 12:18:04 PM »
I am in the same position-  Have you found out how to do it???


Re: Emco VMC100
« Reply #2 on: August 25, 2012, 04:25:38 PM »
pop some pics up of the electronics, so we can have an idea what's used.