Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: 30t000 on September 05, 2010, 05:44:32 AM
-
I am about to embark on a new project to replace the cnc controller on my machine with a pc based Mach3 system . I have not yet decided how to move forward as i will not get the machine until next weekend . Has anyone tried and succeeded in getting one of these little lovelys up and running with Mach3 . If so can you advise on what was used and what problems I may encounter . Thanks for looking .
-
I am in the same position- Have you found out how to do it???
Thanks,
mark
-
pop some pics up of the electronics, so we can have an idea what's used.