servo keep turning

Total Members Voted: 2

Pages: 1 Go Down

0 Members and 2 Guests are viewing this topic.

« on: September 04, 2010, 09:40:38 PM »

my servos are hooked into a geckodriver g320 after I turn the power on the servos start running with stop, need help of how to fix this issue

Logged

uuccimi - novice

« Reply #1 on: September 05, 2010, 12:37:52 AM »

Could it be your encoders are the wrong way round and you are getting run away?
Hood

Logged

« Reply #2 on: September 05, 2010, 01:02:38 PM »

I did try phase a into phase b & viceversa with the same results
[/quote]

Could it be your encoders are the wrong way round and you are getting run away?
Hood

Logged

uuccimi - novice

« Reply #3 on: September 05, 2010, 05:32:42 PM »

Never used DC servos or the Gecko servo drives but could it just be you are needing to do a bit of tuning?
Hood

Logged

Pages: 1 Go Up