Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: uuccimi on September 04, 2010, 09:40:38 PM

Title: servo keep turning
Post by: uuccimi on September 04, 2010, 09:40:38 PM

my servos are hooked into a geckodriver g320 after I turn the power on the servos start running with stop, need help of how to fix this issue

Title: Re: servo keep turning
Post by: Hood on September 05, 2010, 12:37:52 AM

Could it be your encoders are the wrong way round and you are getting run away?
Hood

Title: Re: servo keep turning
Post by: uuccimi on September 05, 2010, 01:02:38 PM

I did try phase a into phase b & viceversa with the same results
[/quote]

Quote from: Hood on September 05, 2010, 12:37:52 AM

Could it be your encoders are the wrong way round and you are getting run away?
Hood

Title: Re: servo keep turning
Post by: Hood on September 05, 2010, 05:32:42 PM

Never used DC servos or the Gecko servo drives but could it just be you are needing to do a bit of tuning?
Hood