Hi All
I finally got the encoder card to work. It seems now I have a new set of problems I didn`t have
before I installed the card.
For some reason now I cannot seem to home the machine. I made no changes to the homing
section during the configuration of the SL encoder board. All my homing worked before I installed the encoder board.
I can manually trigger the homing switches. Ref All just will not move to the z home then to the y and then
x home.
Also, now when I load code and try to run it I see a message > Nothing to feed hold. As a result, no
axis moves. I can jog all axes but can`t run any real projects on the machine. I asked art about this
and here`s the answer The message "Nothing to Feedhold" means that the system is sensing the
feedhold being pressed, it will not pop up otherwise. OR, somehow a OEMtrigger is set to pause the system automatically or something..
Regards barry