Hello Guest it is December 01, 2024, 04:23:41 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Ekstrom Carlson Spindle  (Read 6019 times)

0 Members and 1 Guest are viewing this topic.

Offline Smackre

*
  • 57 57
Ekstrom Carlson Spindle
« on: October 20, 2006, 07:53:30 AM »
Well i just ordered a Ekstrom Carlson Spindle to replace my porter cable.  I just couldnt deal with the run-out any longer.

Can anyone give me a rundown on the best way to wire the VFD to mach3?  The simplist way.
Logged

Offline Chaoticone

*
  • *
  • 5,624 5,624
  • Precision Chaos
Re: Ekstrom Carlson Spindle
« Reply #1 on: October 20, 2006, 08:10:21 AM »
Do you have a breakout board with an analog output?
Logged
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!

Offline Smackre

*
  • 57 57
Re: Ekstrom Carlson Spindle
« Reply #2 on: October 20, 2006, 08:28:55 AM »
My breakout board is simple.  All it has it the lpt port and blocks to connect wires.  I do not think it has a analog output.
Logged

Offline Chaoticone

*
  • *
  • 5,624 5,624
  • Precision Chaos
Re: Ekstrom Carlson Spindle
« Reply #3 on: October 20, 2006, 09:05:57 AM »
Does your VFD have to see a varying input voltage to vary the speed? Any VFD I have fooled with works this way. Do you have any wiring diagrams you can post, or a link? Look at these and see if it helps.
http://www.campbelldesigns.com/mach-spindle-speed-control.php
http://www.cnc4pc.com/Variable_Speed_Control_Board.htm

« Last Edit: October 20, 2006, 03:04:23 PM by Chaoticone »
Logged
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!
Pages: 1   Go Up
« previous next »