Hello Guest it is January 26, 2021, 01:59:09 PM

Author Topic: Encoder feedback  (Read 1732 times)

0 Members and 1 Guest are viewing this topic.

Encoder feedback
« on: July 08, 2010, 03:16:25 PM »
I've read through most of the posts here and one of them talks about not reading encoders.  I'm not getting feedback, and I'm not sure why.

I have a DMC-2143 card.  I can see the encoders are working with a TPA command in GalilTools, and if I spin the motor, I can see the Units/min register report the speed in Mach.  But, if Mach reads the encoders to report the speed, why doesn't it display position in the position DRO?  Is there a special type of DRO box for this?