Machsupport Forum
Third party software and hardware support forums. => Galil => Topic started by: Flipz01 on July 08, 2010, 03:16:25 PM
-
I've read through most of the posts here and one of them talks about not reading encoders. I'm not getting feedback, and I'm not sure why.
I have a DMC-2143 card. I can see the encoders are working with a TPA command in GalilTools, and if I spin the motor, I can see the Units/min register report the speed in Mach. But, if Mach reads the encoders to report the speed, why doesn't it display position in the position DRO? Is there a special type of DRO box for this?