Hi BOGIE:
If you are using my Z Zero routine there is some additional information you need to set your Z Axis height after the touch.
In the code look for "ZNew = Plate Offset + .937 This is in the Imperial section at the top of page.
You will need to change the number .937 to compensate for the touch plate thickness and your new Z height after the touch.
Here is how it works.
My touch plate is .063 thick. I wanted to withdraw the Z Axis to 1 inch above the work surface. I subtracted .063 from 1 inch, the result, .937 goes in the line of code.
So to set your final Z height after touch, subtract your touch plate height from the final height you want Z to go to and put that number in the "ZNew" line in the VB Code.
As my routine does both Imperial and Metric in the same routine, for Metric you need to go down further in the program and do the same calculations, using Metric numbers, in place of the "20" shown there now.
Hope this helps,
George