Hello Guest it is May 05, 2025, 07:28:38 PM
Profile Guest
« previous next »
Pages: « 1 2 3 4 5 6 7   Go Down

Author Topic: Setting Mach 3 Port to PCI parallel port address  (Read 250186 times)

0 Members and 2 Guests are viewing this topic.

Offline brian42120

*
  • 13 13
Re: Setting Mach 3 Port to PCI parallel port address
« Reply #60 on: November 21, 2018, 07:38:33 PM »
I’m not shame to admit Craig, that clearly describe me at this point
Logged

Offline TPS

*
  • 2,576 2,576
Re: Setting Mach 3 Port to PCI parallel port address
« Reply #61 on: November 22, 2018, 01:30:53 AM »
attached a principal sheme for a Hardware circuit to do the squaring via relay/optocoupler.



@Craig
i absolutly aggre with you according XHC
Logged
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.

Offline brian42120

*
  • 13 13
Re: Setting Mach 3 Port to PCI parallel port address
« Reply #62 on: November 22, 2018, 05:46:17 AM »
I would have to do something like that if everything else fails...
I heard back from XHC, they told me to tick off A-axis in ports and pins
Logged

Offline brian42120

*
  • 13 13
Re: Setting Mach 3 Port to PCI parallel port address
« Reply #63 on: December 02, 2018, 09:41:28 PM »
Well, just a quick update... it’s been over a week now since I last heard from HXC, they asked for some setup information, I sent it but no reply yet, I may just ask for money back and get something different...I will update again soon...
Logged
Pages: « 1 2 3 4 5 6 7   Go Up
« previous next »