I am running a GCODE, for operate wheel of sewing machine in an embroider project.
In this moment Iam using Z axis for this movement, until I change for A axis.
My set up of Z axis is in this way
Steps x Revolution = 800 (200- ΒΌ microstep)
Mm x revolution = 10 (simulated)
Steps x MM = 80.
Vel 3000 mm/min
Accel = 500 mm/sec/sec
I created two variants of CGODE Lines
For two variants F = 3000
1-G00 Z10----------In this case 100 first lines runs in 59 secs
2- G01 Z10---------In this case 100 first lines runs in 45 secs.
I think that GCODE with G00 in Z movements should be more faster than second variant.
What do you think about that?
Thanks in advance, sorry my bad English.
Regards
Rene