Hello,
I have not been doing anything on my machine for a few months. Now I'm back in my workshop and I have some questions. I think my tuning graph in axisworks looks ok, but when I try to run g-code in mach3 the accelerations in the sharp corners are very rough. It sounds very rough in change direction in high speeds. Is that because mach3 outputs trpezoidal motion? In mach3 settings I have to set accelarations and speeds ~4 times slower to achive more smooth motion. I'v tried to use tempest planner in mach3 which puts out s-curve motion and it was smoother, but tempest planner is not fully supported. Is there any way to achieve smoother motion in higher speeds?
Best regards,
Peter