Hello Guest it is October 16, 2019, 06:37:42 AM

Author Topic: Growing.  (Read 1843 times)

0 Members and 1 Guest are viewing this topic.

Growing.
« on: February 25, 2010, 04:09:15 PM »
Hi all,
I am new to this, not only the forum but running a CNC machine. Over the winter I  have had a small mill built. In the last few days I have run a program to surface the main board and to cut the hole pattern for my hold downs. I have cut a template using the next program. My question is when I ran the template program for a fourth time the profile has grown approximately 20mm all round, Why? What have I clicked that I should not have.

Mike

Offline Hood

*
  •  25,855 25,855
  • Carnoustie, Scotland
    • View Profile
Re: Growing.
« Reply #1 on: February 25, 2010, 04:14:05 PM »
Make sure you dont have any scaling in effect.
Hood