Hello Guest it is December 13, 2019, 09:12:52 PM

Author Topic: Mix of Servo/Stepper motors  (Read 2272 times)

0 Members and 1 Guest are viewing this topic.

Mix of Servo/Stepper motors
« on: September 27, 2006, 09:19:46 AM »
Hi guys.
I have a benchmill/drill Im converting and already have the X & Y axis done, Using Gecko 320's and some
Pittman Lo-Cog Servo's.
I have several high end stepper motors in storage and was wondering If I can use a Stepper for the Z axis
along with the two servo's already in service ?
I have a second Parallel port I can use.
Anybody already do this ?
Thanks.

Paul In Texas.
Re: Mix of Servo/Stepper motors
« Reply #1 on: September 27, 2006, 09:47:28 AM »
Dooh !!
Searched the Yahoo forum and found many Yes's  :)

Srry  ;D