Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Yodawill2000 on September 27, 2006, 09:19:46 AM
-
Hi guys.
I have a benchmill/drill Im converting and already have the X & Y axis done, Using Gecko 320's and some
Pittman Lo-Cog Servo's.
I have several high end stepper motors in storage and was wondering If I can use a Stepper for the Z axis
along with the two servo's already in service ?
I have a second Parallel port I can use.
Anybody already do this ?
Thanks.
Paul In Texas.
-
Dooh !!
Searched the Yahoo forum and found many Yes's :)
Srry ;D