I am getting cumulative error that i have not noticed before. I am using a simple 3 axis router table and after running just a little while, i hit the verify button and pretty high error. I recently upgraded the computer that is using an PCI Parallel card. I have tried slowing down the acceleration and speed, but it does not seem to help. I have run the driver test and it starts by saying pulsing too fast, then it restarts and says my connection is excellent, but the green bar is only about half way. Everything seems real tight on the machine and its well lubricated. I suspect the new computer/configuration since I have never noticed the error before on much larger routines it would always keep up. Any ideas what I can try.
Thanks,
Charlie