On the tool offsets page there is edge finder and center finder and when I click on the buttons nothing happens.  Do I have to do some set up?  is there somewhere I can go to find out how to use these functions?

I don't remember where I saw it, but someone has a macro for that. It might be on the cnc zone forum. I'll look today and see if I can find it.

Dave

Sawdustman18

Here's a few threads on the subject.

http://www.artsoftcontrols.com/forum/index.php?topic=2136.0

http://www.cnczone.com/forums/showthread.php?t=36099&highlight=touch+probe+code&page=32

http://www.cnczone.com/forums/showthread.php?t=56079


There's a lot of reading there, but all good information.

Dave