Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: sawdustman18 on January 26, 2010, 03:17:01 PM
-
On the tool offsets page there is edge finder and center finder and when I click on the buttons nothing happens. Do I have to do some set up? is there somewhere I can go to find out how to use these functions?
-
I don't remember where I saw it, but someone has a macro for that. It might be on the cnc zone forum. I'll look today and see if I can find it.
Dave
-
Sawdustman18
Here's a few threads on the subject.
http://www.artsoftcontrols.com/forum/index.php?topic=2136.0
http://www.cnczone.com/forums/showthread.php?t=36099&highlight=touch+probe+code&page=32
http://www.cnczone.com/forums/showthread.php?t=56079
There's a lot of reading there, but all good information.
Dave