Hello Guest it is August 12, 2020, 09:11:11 PM

Author Topic: A Really Exceptional Vendor....  (Read 5796 times)

0 Members and 1 Guest are viewing this topic.

Re: A Really Exceptional Vendor....
« Reply #10 on: January 26, 2010, 11:10:27 AM »
BarryB,

I know you shouldn't have, to but did you not look for a manual in the internet ?

i know how hard it is to understand them when you have the manual. ;D

Phil
The Good Thing About Mach3, Is It's very Configurable

The Bad Thing About Mach3, Is It's Too Configurable

Offline BarryB

*
  •  267 267
    • View Profile
Re: A Really Exceptional Vendor....
« Reply #11 on: January 26, 2010, 12:15:30 PM »
Heh, of course I did.  I found one that had very similar error codes and numbers from HSD.  HSD insisted it was wrong and the one sent from SIRCO was right.  At that point I vowed to never buy anything from them again and preach the gospel of the good vendors I did have.

I must say one of the exceptional ones was Home Shop CNC.  He met me on a Saturday to correct a milling problem I had.  I didn't expect that kind of service.

Barry

Re: A Really Exceptional Vendor....
« Reply #12 on: January 26, 2010, 12:31:25 PM »
Heh, of course I did.  I found one that had very similar error codes and numbers from HSD.  HSD insisted it was wrong and the one sent from SIRCO was right.  At that point I vowed to never buy anything from them again and preach the gospel of the good vendors I did have.

I must say one of the exceptional ones was Home Shop CNC.  He met me on a Saturday to correct a milling problem I had.  I didn't expect that kind of service.

Barry



I'll second that.  Rick LaLonde is definitely one of the good guys.  I've been buying from him for years, and never been disappointed.

Regards,
Ray L.
Regards,
Ray L.