Hi, thanks.
Tool path was created using Mastercam.
First tool path was with a 5/16 4 flutes end mill, If I remember, depth of cut was about .070" at 25 inches per minute, 8000 RPM. ( Pocket Island Roughing)
Second tool path was with the same 5/16 end mill to rough the tiger head itself, .04 depth of cut at 25 inches per minute (Surface Rough Pocket)
Third tool path was with a 1/4 ball nose, maybe 15000 RPM at 25 inches per minute. (Surface High Speed, Roughing Radial at 1 degree)
Fourth tool path was with 1/8 ball nose, 18000 RPM at 50 inches per minute. (Surface High Speed, Finish Radial at .7 degree)
Last tool path was with a 1/16 ball nose, 24000 RPM, .005 depth of cut and 20 inches per minute. (Surface Finish Shallow)
Has been cut in a 4 X 4 X 1 block, so head is about 3 1/2 X 3 1/2 X 1 inch.
For cutting time, maybe 4 hours.
Do you know who draw this Tiger Head, it is absolutely fantastic.
Jeff