Hello Guest it is February 03, 2026, 04:25:06 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Could G code acces a DRO  (Read 7389 times)

0 Members and 2 Guests are viewing this topic.

Offline M250cnc

*
  • 591 591
Could G code acces a DRO
« on: December 23, 2009, 05:14:35 AM »
With a user DRO set up could G code run, that accessed that DRO ?

Phil
Logged
The Good Thing About Mach3, Is It's very Configurable

The Bad Thing About Mach3, Is It's Too Configurable

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Could G code acces a DRO
« Reply #1 on: December 23, 2009, 06:33:48 AM »
Should be able to do it via a custom m code.
Ray is the guy to tell you hoe to do it the best way, my VB is basic to say the least ;D
Hood
Logged

Offline ger21

*
  • *
  • 6,295 6,295
    • The CNC Woodworker
Re: Could G code acces a DRO
« Reply #2 on: December 23, 2009, 07:21:56 AM »
Put your VB code accessing the DRO in a macro, and call the M code in your g-code.
Logged
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html

Offline M250cnc

*
  • 591 591
Re: Could G code acces a DRO
« Reply #3 on: December 23, 2009, 10:48:34 PM »
Quote from: ger21 on December 23, 2009, 07:21:56 AM
Put your VB code accessing the DRO in a macro, and call the M code in your g-code.

Sounds great, Thanks
Logged
The Good Thing About Mach3, Is It's very Configurable

The Bad Thing About Mach3, Is It's Too Configurable
Pages: 1   Go Up
« previous next »