Hello Guest it is March 28, 2024, 07:28:16 AM

Author Topic: Could G code acces a DRO  (Read 2807 times)

0 Members and 1 Guest are viewing this topic.

Could G code acces a DRO
« on: December 23, 2009, 06:14:35 AM »
With a user DRO set up could G code run, that accessed that DRO ?

Phil
The Good Thing About Mach3, Is It's very Configurable

The Bad Thing About Mach3, Is It's Too Configurable

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Could G code acces a DRO
« Reply #1 on: December 23, 2009, 07:33:48 AM »
Should be able to do it via a custom m code.
Ray is the guy to tell you hoe to do it the best way, my VB is basic to say the least ;D
Hood

Offline ger21

*
  • *
  •  6,295 6,295
    • View Profile
    • The CNC Woodworker
Re: Could G code acces a DRO
« Reply #2 on: December 23, 2009, 08:21:56 AM »
Put your VB code accessing the DRO in a macro, and call the M code in your g-code.
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html
Re: Could G code acces a DRO
« Reply #3 on: December 23, 2009, 11:48:34 PM »
Put your VB code accessing the DRO in a macro, and call the M code in your g-code.

Sounds great, Thanks
The Good Thing About Mach3, Is It's very Configurable

The Bad Thing About Mach3, Is It's Too Configurable