Hello Guest it is August 23, 2019, 01:18:12 AM

Author Topic: plasma mach motor tuning  (Read 1725 times)

0 Members and 1 Guest are viewing this topic.

plasma mach motor tuning
« on: December 02, 2009, 09:43:08 AM »
A few times when I reinstalled Mach,
then re-configured the ports, pins and general config.
After, I cannot get the motor tuning to work.  Any ideas??
I appreciate it.

Online Tweakie.CNC

*
  • *
  •  7,885 7,885
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: plasma mach motor tuning
« Reply #1 on: December 02, 2009, 12:21:47 PM »
Try reloading Mach again -  it could be that the driver file has not loaded correctly.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.