Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: ironarbor on December 02, 2009, 09:43:08 AM

Title: plasma mach motor tuning
Post by: ironarbor on December 02, 2009, 09:43:08 AM

A few times when I reinstalled Mach,
then re-configured the ports, pins and general config.
After, I cannot get the motor tuning to work.  Any ideas??
I appreciate it.

Title: Re: plasma mach motor tuning
Post by: Tweakie.CNC on December 02, 2009, 12:21:47 PM

Try reloading Mach again -  it could be that the driver file has not loaded correctly.

Tweakie.