Hello Guest it is March 28, 2023, 11:24:45 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Spindle E-stop  (Read 2601 times)

0 Members and 1 Guest are viewing this topic.

Offline ibyte2

*
  • 2 2
    • View Profile
Spindle E-stop
« on: September 10, 2006, 10:22:18 AM »
Morning All,

Looking for a electrical circuit to add e-stop for the spindle. Using Gecko 201 controllers on a KT 2514

Thanks
 Ron
« Last Edit: September 10, 2006, 12:42:16 PM by ibyte2 »
Logged

Offline Brian Barker

*
  • *
  • 3,856 3,856
    • View Profile
Re: Spindle E-stop
« Reply #1 on: September 12, 2006, 10:58:54 AM »
You should be able to put ina relay to set the disable pin on the G201...
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Pages: 1   Go Up
« previous next »