Hi all.
I am new to the forum and Mach3
I have some serious problems trying to get my stepper motors to run properly.
I will try to give a full description of the setup and issues.
Drive 1
IMS IB106. 24v - 80v, 1 - 6 amps, Full or 1/2 step.
I have 3 of these and they are new.
Drive 2
Superior electric, Slo-Syn, SS2000MD7, 24v - 75v, 1 -7amps, 2 - 100 resolution.
Supposed to be new but I have doubts.
Motor 1
Astrosyn, L281, 3v, 1.7 amp, 15Kg cm, Hybrid
I have 2 of these new
Motor 2
Pacific Scientific, Powermax, P22RXA LDS NS 02, 2.7v, 4.6amp, unipolar.
I have 2 of these used.
Motor 3
SuperiorElectric, Slo-Syn, M112 FJ 319B (same as8018 I think) 2.1v, 9.2amp, 840 oz in
Just the one, used
I am at the initial bench testing stage, and seem to be stuck. I hope to be fitting the system to a bridgeport sized mill when compleet.
All 3 IMS drives seem to work perfectly with the Astrosyn motors, forward,back,fast,slow. Power Supply is 48v DC unregulated, approx 30amp capacity.
When I connect the other motors I get the same effect every time. The motors try to run but verry eratic and noisy, they do try to go forwards and back but always verry rough. I have tried all the diferent wiring methods to no success.
The Slo-Syn drive will not work with any of the motors, they all try to run but again verry rough.
Sorry it such a long post but I thought it best to try and give a full picture
Any help gladly recived
John