Hello Guest it is March 28, 2024, 08:10:13 AM

Author Topic: touch plate question  (Read 2478 times)

0 Members and 1 Guest are viewing this topic.

touch plate question
« on: November 04, 2009, 03:36:59 PM »
Can someone explain to me the tool height and touch probe thing.  I am currently using a Littlemachine shop manual edge finder for x and y.  For Z i am using zigzag paper.  once they all are zeroed i zero my DRO.  am i doing it wrong?  will this touch probe thing make it easier to do the same thing.  I was talking to another guy and he said to use an electronic edge finder without the battery.  With out the battery the tip is isolated and can be used as a probe i guess. I guess i do not really understand the point or the operation enough to event field the questions i want answered.

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
Re: touch plate question
« Reply #1 on: November 05, 2009, 03:04:05 AM »
There are quite a few explanations for use of the touch plate here on the forum but, if you wish, you can see how I set up my tool positioning here:-
http://www.cooperman.talktalk.net/files/17.htm

Hope this helps.

Tweakie.
PEACE