Hello Guest it is September 25, 2020, 02:52:59 PM

Author Topic: Loadfile from a push button  (Read 3102 times)

0 Members and 1 Guest are viewing this topic.

Offline Pich

*
  •  11 11
    • View Profile
Loadfile from a push button
« on: November 04, 2009, 11:45:00 AM »
I'm new at this, and I was wondering if I could accomplish this task with brain.
Load an NC file from a push button and then run it, by pressing a different push button it would close the one loaded and load a different file.
John

Offline poppabear

*
  • *
  •  2,233 2,233
  • Briceville, TN, USA
    • View Profile
    • S S Systems, LLC
Re: Loadfile from a push button
« Reply #1 on: November 04, 2009, 11:52:35 AM »
something like that would best be implemented in the macro pump

scott
Commercial Mach3 & Mach 4, Design/Build/Retrofit CNC and Industrial machines.
http://www.ss-systems-llc.com/
Re: Loadfile from a push button
« Reply #2 on: November 04, 2009, 12:11:02 PM »
Hi John,
 Check out this thread......especially the last page.
http://www.machsupport.com/forum/index.php/topic,11469.50.html
It works pretty cool.
Might be what you need.
Russ

Offline Pich

*
  •  11 11
    • View Profile
Re: Loadfile from a push button
« Reply #3 on: November 04, 2009, 12:33:20 PM »
Will do
Thanks a lot guys

Offline Bill_O

*
  •  307 307
    • View Profile
Re: Loadfile from a push button
« Reply #4 on: November 06, 2009, 09:14:55 AM »
This would need modified but take a look at this post.
http://www.machsupport.com/forum/index.php/topic,10910.0.html
Bill