Hello Guest it is September 19, 2020, 06:55:05 PM

Author Topic: Quick question.  (Read 1989 times)

0 Members and 1 Guest are viewing this topic.

Quick question.
« on: October 22, 2009, 02:37:27 AM »
I am using mastercam and mach3 to run my operations. But for some reason I keep getting this error message every time I load particular codes. Current point same as end point of arc on line number #.
Can anybody help me out. I have stared at this thing for hours.


Offline RICH

  • *
  •  7,412 7,412
    • View Profile
Re: Quick question.
« Reply #1 on: October 22, 2009, 06:55:02 AM »
Could be a number of things ie; post processor, the arc Gcode used, etc.

I suggest you read the MACH3 Turn Arc Motion Tutorial which is in the Members Docs. Here is the link:


That will give you a good understanding on arc programing.