Hello Guest it is April 16, 2024, 07:21:59 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Spindle want run  (Read 3851 times)

0 Members and 1 Guest are viewing this topic.

Offline racear2865

*
  • 50 50
    • View Profile
Spindle want run
« on: October 15, 2009, 12:27:00 PM »
I downloaded latest upgrade to Smooth Stepper and Mach 3. Now spindle will not run. Tried going back to earlier, but still will not run. Spindle will run from VFD so it is ok. Any suggestions. and I will tell you now I am far from being an expert at this
racear
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Spindle want run
« Reply #1 on: October 15, 2009, 01:54:23 PM »
Check in the plugin that you have the correct setting for the type of spindle control, it has probably reset to none.

Hood
Logged

Offline racear2865

*
  • 50 50
    • View Profile
Re: Spindle want run
« Reply #2 on: October 15, 2009, 02:38:17 PM »
Hood thanks for reply. Already thought of that and looked: is on???
racear
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Spindle want run
« Reply #3 on: October 15, 2009, 03:00:25 PM »
How is your spindle connected, what pins do you need and check they are all still set correctly, also make sure if you use Step/Dir that it is enabled and that any outputs for the spindle have the correct pins set and that the spindle relays if used are not disabled on Spindle Control page  of Ports and Pins.
Hood
Logged

Offline racear2865

*
  • 50 50
    • View Profile
Re: Spindle want run
« Reply #4 on: October 15, 2009, 03:27:01 PM »
Hood. I have a Smooth Stepper pined to a Campbell card. I looked at Outputs and it showed PWM first and I changed it to step/dir but still want run.
racear
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Spindle want run
« Reply #5 on: October 15, 2009, 04:19:32 PM »
You could try going back to a previous xml.
Hood
Logged
Pages: 1   Go Up
« previous next »