Hello Guest it is October 09, 2024, 11:59:37 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Master Cam9 Issue  (Read 3998 times)

0 Members and 1 Guest are viewing this topic.

Offline SScnc

*
  • 77 77
Master Cam9 Issue
« on: October 16, 2009, 11:03:50 AM »
I loaded the MasterCam9 Post processor off the mach3 page and installed it. When i post the code I get the first picture. It is suppse to look something like the 2nd picture. Any Ideas?
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Master Cam9 Issue
« Reply #1 on: October 16, 2009, 11:29:29 AM »
Change the IJ mode on the general config page.
Hood
Logged

Offline SScnc

*
  • 77 77
Re: Master Cam9 Issue
« Reply #2 on: October 16, 2009, 01:17:00 PM »
Fixed thanks a million

-Scott
Logged
Pages: 1   Go Up
« previous next »