Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: SScnc on October 16, 2009, 11:03:50 AM

Title: Master Cam9 Issue
Post by: SScnc on October 16, 2009, 11:03:50 AM

I loaded the MasterCam9 Post processor off the mach3 page and installed it. When i post the code I get the first picture. It is suppse to look something like the 2nd picture. Any Ideas?

Title: Re: Master Cam9 Issue
Post by: Hood on October 16, 2009, 11:29:29 AM

Change the IJ mode on the general config page.
Hood

Title: Re: Master Cam9 Issue
Post by: SScnc on October 16, 2009, 01:17:00 PM

Fixed thanks a million

-Scott