Hello Guest it is April 14, 2021, 04:18:26 AM

Author Topic: Master Cam9 Issue  (Read 2520 times)

0 Members and 1 Guest are viewing this topic.

Offline SScnc

*
  •  77 77
    • View Profile
Master Cam9 Issue
« on: October 16, 2009, 11:03:50 AM »
I loaded the MasterCam9 Post processor off the mach3 page and installed it. When i post the code I get the first picture. It is suppse to look something like the 2nd picture. Any Ideas?

Offline Hood

*
  •  25,838 25,838
  • Carnoustie, Scotland
    • View Profile
Re: Master Cam9 Issue
« Reply #1 on: October 16, 2009, 11:29:29 AM »
Change the IJ mode on the general config page.
Hood

Offline SScnc

*
  •  77 77
    • View Profile
Re: Master Cam9 Issue
« Reply #2 on: October 16, 2009, 01:17:00 PM »
Fixed thanks a million

-Scott