Hi, A couple of questions for the software guys, I've been having

problems with chatter on the end of a cut (see Tangent Corner-

Denford Orac problem)  Since renewing the chuck and trying different

things to solve the problem I have come to realise that there is a

delay when going from a G1 command to a G0 command.

After I have taken a cut and need to back up the tool a bit to rapid

back to take the next cut, the tool just sits there for a bit causing

the tool to rub on the work.

I have changed my G-code listing so that the  G0 rapid off after feed

cut to G1 and there is less of a wait before the next movement.


This has reduced the chatter problem 50%

I'm guessing that this may be due to using a 800mhz computer.


My question is, will increasing processor speed reduce the delay

between commands (G0 AND G1 etc:) and also will increasing the Kernel

speed help.   




Many Thanks